A Brief History of the Metric System

I was quite surprised at the substantial cost of A Brief History of the Metric System, and when it arrived, that it was only about 6 mm thick. I was unprepared for its fealty to contemporary research on the origins of the metric system. I can say, without equivocation that the discussion of the metric system—though brief (as the title states) is the most complete I have seen. Carmen J. Giunta states early in Chapter 1:

The metric system did not “evolve” from the customary weights and measures in use in late eighteenth-century France, but neither did it spring fully formed from the enlightened minds of that nation’s savants.

He hints that the history as it has been portrayed in the past has been incorrectly stated. He immediately begins to discuss John Wilkins and Christopher Wren’s musing on what the basis of a universal measurement system might consist. He mentions details of Wilkins investigation of which I was previously unaware. Wilkins discussed using the Earth as a basis for measurement, but dismissed it as impractical. Giunta traces the idea of using a seconds pendulum as a basis for length back far earlier than Wilkins, and how Jean Picard (1620-1682) suggested in 1671 that the period of the seconds pendulum might vary with latitude. He goes on to describe how there was an anemic attempt in Britain to address weights and measures with a seconds pendulum, around the time the metric system was under discussion in France, by John Riggs Miller (c. 1744-1798) which fizzled out.

Giunta’s discussion of measurement contemplation and (non adoption) in the United States contains a number of interesting historical nuggets I had not previously encountered.

For such a short monograph, Giunta has a more nuanced discussion of the creation of the metric system in France than I have encountered with other authors. He states:

Other committees constituted in 1791 included Borda and Cassini to measure the seconds pendulum;……”

Other authors generally do not discuss the elaborate seconds pendulum designed and measured by the French scientists who developed the metric system.

His discussion of the development of modern SI states:

When the SI was launched, the kilogram was the base unit of mass, defined by the international prototype kilogram of 1889. A proposal was made to change the name of kilogram since it was undesirable for one of the base units to have a prefix, but the name survived.

Long-time readers know that the use of a lower case k for kg, km, kN, etc., has always been a pet peeve of mine. Other magnifying prefixes are capitalized, Mg, Tg, GHz, why not Kg or Km?

There have been a number of proposals for base units, but this was new to me:

In Germany, the preferred set of mechanical base units was the millimeter, milligram, and second; call it mms.

In Chapter 6, his final chapter, he discusses The Metric System and the United States. He gives a good summary, but then, in my reading of history, and of John Quincy Adams’ report on measures Giunta has an incorrect interpretation of the concluding paragraph of that report. He states:

Adams was effusive in his praise of the metric system and of the basic science that came out of its invention.

Adams’ concluding statement was actually veiled snark, and certainly not a pro-metric statement given the context of his report. Adams was an Anglophile with an English wife. It becomes clear in his report that Adams is NOT pro-metric, and definitely against the new system. Others in history who read the report in the late 19th and early 20th century commented that it was anti-metric, and held back metrication in the US. They even point out that his “perfect” English system, only 3 years after his report, was reformed and replaced in the UK by the British Imperial System. We in the US still use earlier British medieval units of measure. My discussion of JQA’s report may be found here.

Giunta offers a graphic from NIST showing a metaphor of an iceberg that almost all of industry uses metric. I’ve never seen a study that can even demonstrate we are even 50% metric in the US, let alone 90%. My experience as a consulting engineer is that I have not encountered a single medium sized corporation that uses metric in the US. Certainly not aerospace, which is definitely a large corporation. If the book Flying Blind is any guide, aerospace will remain non-metric indefinitely.

Giunta finally concludes by offering his view of Why is the US Still not Predominantly Metric? He concludes, like many others, that the US government has never mandated
metric for use in our economy. He is correct that it is very unlikely the US will become metric anytime soon. Perhaps in 1000 years?


If you liked this essay and wish to support the work of The Metric Maven, please visit his Patreon Page and contribute. Also purchase his books about the metric system:

The first book is titled: Our Crumbling Invisible Infrastructure. It is a succinct set of essays  that explain why the absence of the metric system in the US is detrimental to our personal heath and our economy. These essays are separately available for free on my website,  but the book has them all in one place in print. The book may be purchased from Amazon here.


The second book is titled The Dimensions of the Cosmos. It takes the metric prefixes from yotta to Yocto and uses each metric prefix to describe a metric world. The book has a considerable number of color images to compliment the prose. It has been receiving good reviews. I think would be a great reference for US science teachers. It has a considerable number of scientific factoids and anecdotes that I believe would be of considerable educational use. It is available from Amazon here.


The third book is called Death By A Thousand Cuts, A Secret History of the Metric System in The United States. This monograph explains how we have been unable to legally deal with weights and measures in the United States from George Washington, to our current day. This book is also available on Amazon here.

Stream of Metric Consciousness

By The Metric Maven

A coffee klatch denizen, NY Joe, kindly brought me a book titled The Macmillan Dictionary of Measurement. It has over 4250 entries and Joe was sure I’d find it interesting reading. He was right, there are many interesting aspects of the book that caught my attention, and some not in a good way. One entry took me by surprise and would have been a nice addition to my DBTC chapter Multiple Metric Systems and Metrology. There I point out the existence of the MKS (meter-kilogram-second), CGS (centimeter-gram-second) and MTS (meter-tonne-second) systems. I encountered an entry about the crinal in this dictionary, which I reproduce below:

Yes, the DKS decimeter-kilogram-second system!? I’ve encountered this system no where else in my research over the years. One might almost think it a joke, but then I’ve seen the seemingly unending historical pre-metric units, and many of them also appear to be jokes. My favorite reference has a crinal in it, and the first definition is 1 decinewton. Indeed, let’s just rid ourselves of the prefix cluster around unity. This is unit proliferation, pure and simple.

I also learned that base ten logarithms, like that used to define the decibel, are called Briggs logarithms after the early British mathematician Henry Briggs (1561-1631). In 1616 he drew up the first base ten logarithm tables. Who knew? For those who find British Thermal Units too straightforward, there is also the CHU or centigrade heat unit, equal to the quantity of heat required to raise the temperature of 1 pound of water by 1 degree celsius. That is a serious pigfish definition. It is also known as the pound-calorie. The international angstrom is a unit of length, but it is defined with a red line in the cadmium spectrum, at a temperature of 15 C and a pressure of 760 mm of mercury which is 6438.4696 international angstroms. “It is very nearly the same as an ANGSTROM UNIT (10-10 m).” What? very nearly the same? Why not call it “the horseshoe?” We also encounter a prefixed angstrom called a milliangstrom. We need a unit that is 10-13 m in length? There is also the kip, which is a: “Little-used unit of mass for measuring the load on a structure equal to 1,000 pounds avdp. (half a short ton). It was named after the first letters of kilo imperial pound.” This is serious pigfish on parade. Shoe sizes are defined, but mondopoint does not have an entry, or a single mention in the dictionary. I have written about mondopoint here and here.

The dictionary even relates a unit called the eric:

Eric [comparative values] In medieval Ireland, the blood money paid by a murderer or accidental killer (to his family) to the victim’s family in full and complete satisfaction for the death, so that no further punishment or obligation would be imposed or sought.

There is also “the finger.” As we know a hand is about 100 mm in width. Four fingers of width implies a finger would be about 20 mm (25 if the world made sense). Of course in old timey movies we see western characters order two or three fingers of alcohol, which is not exactly independent of the size of the glass.

This dictionary has very little use for milli. Millimeters and milliliters appear depreciated for centimeters and centiliters. When millimeters do appear it is often with mixed fractions.

The dictionary has the Kilotonne, which is a metric prefix applied to a Megagram which is actually a Gigagram as I point out in my essay A Kilotonne is how much in metric? The dictionary lists (with lower case of course) a megabar, megabit, megacurie, megadyne, megahertz, megajoule, megaparsec, megarad, megaton, megavar, megavolt, megawatt, and megaohm, but no Megagram! Clearly the authors of this reference, need to become a bit more acquainted with the metric system in my view. They proudly have listed tonne and kilotonne, but no megatonne, or gigatonne. Both of these nested concatenated prefix “units,” which are megamegagrams or gigamegagrams are seen constantly in reporting about global warming and elsewhere, rather than using Teragrams or Petagrams, which are properly expressed, and devoid of the archaic pre-metric “ton”, which only serves as a thumb to suck, or a skirt to hold are absent. Of course the dictionary also has metric ton and tonne

One day while using public transit to meet with me over brunch, Sven noted a fellow wearing a tee shirt like the one below:

Over the years, there has been a meme of sorts that indicates that spelling is somehow a measure of something that is intellectually indicative about a person. As I’ve pointed out, we have a number of Shakespeare’s signatures, and no two are spelled the same. The two people who wrote this book identify themselves on the dust jacket: “[one]….is a packager who produces popular dictionary and reference books in the fields of science, semantics and medicine” and “[the other]…is an editorial consultant who specializes in religion, foreign languages, place-names, and music.” They both spend an inordinate amount of time defining collective nouns, such as a murder of crows, murmuration of starlings, or a muster of peafowl. These are not exactly precisely defined units or values. The reference is indeed written like what one would expect from specialists in language, who I’m sure can spell, but have no metrology background.

Often people ask me to talk about old archaic pre-metric units, but I have no interest in doing so. There are so many “metric” and “pigfish” sub-optimal units to discuss, and then plead for people stop using; I want to concentrate on them. I encourage people to switch-over to pure efficient metric, without the tonne, micron, angstrom, or other “exceptions.” If you want to know about archaic or obsolete units that no one has ever heard of, consult John Quincy Adams. Relating numbers in the most meaningful manner possible begins with good streamlined metric usage.


If you liked this essay and wish to support the work of The Metric Maven, please visit his Patreon Page and contribute. Also purchase his books about the metric system:

The first book is titled: Our Crumbling Invisible Infrastructure. It is a succinct set of essays  that explain why the absence of the metric system in the US is detrimental to our personal heath and our economy. These essays are separately available for free on my website,  but the book has them all in one place in print. The book may be purchased from Amazon here.


The second book is titled The Dimensions of the Cosmos. It takes the metric prefixes from yotta to Yocto and uses each metric prefix to describe a metric world. The book has a considerable number of color images to compliment the prose. It has been receiving good reviews. I think would be a great reference for US science teachers. It has a considerable number of scientific factoids and anecdotes that I believe would be of considerable educational use. It is available from Amazon here.


The third book is called Death By A Thousand Cuts, A Secret History of the Metric System in The United States. This monograph explains how we have been unable to legally deal with weights and measures in the United States from George Washington, to our current day. This book is also available on Amazon here.

is essay and wish to support the work of The Metric Maven, please visit his Patreon Page.